wheel hexi (marder,firehammer,traveller
 

can someone please advise me as to how to remove wheel hexi's off drive shaft so I can clean and oil hub bearings.They seem stuck solid tried heating with hair dryer.

RE: wheel hexi (marder,firehammer,traveller
 

theres two small alun bolt grub screws that you need to loosen/remove - there sunk into the drive square

RE: wheel hexi (marder,firehammer,traveller
 

Hi,
If the 2 sets screws have been locktite in, then its possible that its got to the shaft and then this can be a pig to get off. The best thing I use is a soldering iron (40watt ish) and put this on the block for a while, then twist and pull. You can use a small blow touch but if you have to much plastic around, TAKE CARE!!...lol
Steve:D

RE: wheel hexi (marder,firehammer,traveller
 

small butane tourch works great for lossening the loctite

RE: wheel hexi (marder,firehammer,traveller
 

tnx guys will try this tnx to all

RE: wheel hexi (marder,firehammer,traveller
 

big torch.. when it's all red then you are go go go;) and that is go go go straight to the store and buy alot of new stuff:)

i would probebly go with the soldering iron.. if you melt the plastic you have to buy new;)
and this is just my thought.. when the plastic is hot.. be careful not bending it:) (all of this you probebly know already)

RE: wheel hexi (marder,firehammer,traveller
 

Ya!! fire! fire!

RE: wheel hexi (marder,firehammer,traveller
 

if its the bearings in the front hubs you want to oil take off the c clip off from the back of the axle shaft then you can pop the bearings out with out the hassle of trying to remove the grub screws

RE: wheel hexi (marder,firehammer,traveller
 

wait... we are supposed to WANT to remove these things ? [X(]


http://aycu23.webshots.com/image/449...0408430_rs.jpg

LMAO !

I can't keep um on and this joker wants to know how to take um off !

hahahaha.

Use a soldering gun on the setscrew nut. Heat it up and the loctite will loosen.