removing flywheel?
i am installing a new crank shaft and piston in my mt5 engine and i am stuck because i catn remove the fly wheel and clutch carier any tips ?
i searched and found a usefull link for removeing the clutch carrier http://www.rcuniverse.com/forum/m_49...tm.htm#4953499 but nothing on removing flywheel any help? |
RE: removing flywheel?
i think this is what your looking for.
pg 14. http://www.rc-lode.cz/images/manual.pdf you got the model/size of engine? 23cc or 26cc? http://www.zenoah.net/products/hobby/hob_index.html pg9 http://www.zenoah.net/products/hobby...G260RC_704.pdf |
RE: removing flywheel?
thanks alot very useful info and i had one more problem removing the crank key
|
RE: removing flywheel?
#28 ?
just a small flat screwdriver and a couple of taps with a hammer should knock it loose. it's a tight fit machined groove. |
RE: removing flywheel?
it is not working i tried hitting it from every angle with every different size screwdriver
|
RE: removing flywheel?
try grabbing it with vise grips and pulling/wiggle. its only in the guide/groove.
i've had some small engine's be very stubborn with that key. snowblower's especialy cause of rust. maybe some heat on the key. |
RE: removing flywheel?
i tried putting a lighter under it for 2-3 mins and hit it pull it but no use?
|
RE: removing flywheel?
Just use two bolts and screw them in the the flyweel and the flywheel come's lose:D
http://img444.imageshack.us/img444/6...iegwielma4.jpg Or make something like this: http://www.racing-paradise.com/shop/...e74b2b7b6c.jpg |
RE: removing flywheel?
uuum ya the key will be hard to come out if the flywheel is still on
|
RE: removing flywheel?
Actually the key will not come out if the flywheel is still on.
|
RE: removing flywheel?
ORIGINAL: mazdab2600 uuum ya the key will be hard to come out if the flywheel is still on It's the problem to remove the bold or the whole flywheel ? |
RE: removing flywheel?
he's tring to remove the key on the crankshaft.
i dont know if hes got the flywheel off or not. |
RE: removing flywheel?
It's impossible to get the key out when the flywheel is still mounted.
First remove the flywheel and then you can get the key out. |
RE: removing flywheel?
i removed the flywheel but the key is a bit*$
|
RE: removing flywheel?
Im not sure but it seems to me that if you have removed the flywheel and the key wont come out fairly east that it may be seized up in the journal/slot. try a mini gear puller or a c-clamp with a piece of scrap metal on the back side of the key.
|
All times are GMT -8. The time now is 02:11 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.