Cluth question?
Hi i have an evo tuned engine that i am just about to put in my MCD race runner, i have bought an hpi clutch with red spring, the thing i have noticed is that i took the old engine out and was looking at the clutch and what washers they used to space it. I noticed they only used the wafer thin ones on top of the clutch! The clutch holder is a flat one like on my new engine.
what i noticed is once you undone the clutch it doesn`t ly exactly flush as the spring is slightly wider than the clutch shoes so without any spacers it is rubbib=ng againg the centre screw on the clutch holder? |My new clutch would sit the same on my new engine, so is it alright like this as i cant see any wear on the old clutch spring, or should i use spacers? Thanks in advance. Guy |
RE: Cluth question?
you may want to post some pictures with certain thing circled so it is easier to clarify what you are talking about
my 2 cents |
All times are GMT -8. The time now is 12:49 AM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.