Go Back  RCU Forums > RC Helicopters > RC Helicopter Beginners Forum
Reload this Page >

AR7000 Fails to bind to DX6e

RC Helicopter Beginners Forum If you are a beginner or "newbie" to RC heli's feel free to post your questions right here in the rc heli beginner forum.

AR7000 Fails to bind to DX6e

Old 11-02-2019, 01:09 PM
Junior Member
Thread Starter
Join Date: Nov 2019
Posts: 1
Likes: 0
Received 0 Likes on 0 Posts
Angry AR7000 Fails to bind to DX6e

Hi all
I am totally new to RC helis and have a second hand TREX450 that came fitted with a Spectrum AR7000 Rx, (but I noted no remote Rx).
I have created a new model for the 450 on my DX6e Tx ( a copy of my TREX470 setup, that will obviously need some tweaks).
I select the model on my Tx, power up the 450 into bind mode and get the orange flashing light.
Then on my Tx, select the bind option but get a "bind failed" message in response.
I'm totally lost with this. Is the remote Rx essential here, or will it work ok without?
I have three models set up on my Tx, the TREX470 which achieved a bind with no problem. NEXT simulator with Spectrum WS1000 dongle on my PC, which also achieved a bind with no problem. Then I have the TREX450 with the AR7000 Rx which refuses to bind. What am I missing here?
Thanks in advance for any advice.

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.