A noobies first flight (hover)
#1
Senior Member
Thread Starter
Join Date: May 2005
Location: eureka,
CA
Posts: 2,798
Likes: 0
Received 0 Likes
on
0 Posts
A noobies first flight (hover)
I got my Honey Bee 2 cp yesterday (my first single rotor) I got everything adjusted and went out to try it and see if I could even hover (noobie here). I didn't pick the best day though, 5 - 10 mph winds (lol) but I actually got it hovering and kept it pretty much in one place for about 30 seconds. I tried it first with the training gear but it wasn't very stable so I took it off and it was much better. Had a few minor crashes of coarse but no damage, just a big grin (lol). I guess all the training with the xrb helped some after all. So far it seems to be fairly tough but I'm sure I'll find something to break (lol). So the rest of you noobies keep at it and don't give up. Now I just need a calm day.
#2
Junior Member
Join Date: May 2005
Location: , UNITED KINGDOM
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
RE: A noobies first flight (hover)
Good on ya fella. like you i started with the XRB corded version and it helped alot then i brought the Hummingbird and can hover and hop....Brings a big smile to my face addios for now and good luck on ya flying.
#3
Senior Member
Thread Starter
Join Date: May 2005
Location: eureka,
CA
Posts: 2,798
Likes: 0
Received 0 Likes
on
0 Posts
RE: A noobies first flight (hover)
Thanks and good luck to you too. I just crashed mine today and broke my brand new ducted fan tail rotor (the motor mounts) Any one need a tail motor for one, brand new with a heat sink?