Blade CP head assembly Help! Shear pin prob
Ok this is almost fun. I was trying to take the head assembly off to check the swashplate, and make a long story short I cannot get the shear pin back in. Does anyone have any tricks thanks a million??
|
RE: Blade CP head assembly Help! Shear pin prob
send the tip of a needle through first to get the hole perfectly aligned then try the pin.
|
RE: Blade CP head assembly Help! Shear pin prob
Thanks I am trying that, but cannot get the center hub to move at all to get aligned. Should it be able to move? Thanks for your promptness too I really appreciate this. I am a newb and just want to get this thing back together.
|
RE: Blade CP head assembly Help! Shear pin prob
I got it!!! Kick butt thanks again paedbo. Have a good one
|
All times are GMT -8. The time now is 11:57 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.