Servo question for a 600 n
03-06-2011, 11:44 AM
#1
Senior Member
Thread Starter
Join Date: Aug 2007
Location: Midland, TX
Posts: 185
Likes: 0
Received 0 Likes
on
0 Posts
Servo question for a 600 n
Question for you guys.....
I have a Trex 600 nitro that is complete minus the electronics.
I have 4 Futaba 9202's and a Futaba 9201 servo.
I also have 5 JR DS821's,
I already have ordered a new tail servo, so Im not worried about that one.
My question is this.
What servo's should I use for the other applications?
Shawn
I have a Trex 600 nitro that is complete minus the electronics.
I have 4 Futaba 9202's and a Futaba 9201 servo.
I also have 5 JR DS821's,
I already have ordered a new tail servo, so Im not worried about that one.
My question is this.
What servo's should I use for the other applications?
Shawn
03-06-2011, 12:48 PM
#2
RE: Servo question for a 600 n
Dont, under any circumstances, use 821's in a nitro.
9202's were THE servo to have for a long time and if you're not doing crack rolls they will do fine.
If you're planning on buying servos then look at 9252,s 9452s, or Align DS 610's
9202's were THE servo to have for a long time and if you're not doing crack rolls they will do fine.
If you're planning on buying servos then look at 9252,s 9452s, or Align DS 610's
