Notices
RC Helicopter General Discussions Discuss RC Helis here. Nitro, gas, turbine and any make, model or brand not having its own specific forum below!

Machine Screws

Old 01-07-2012, 04:13 PM
  #1  
mossman77
Junior Member
Thread Starter
 
Join Date: Jan 2012
Location: Dumfries, VA
Posts: 25
Likes: 0
Received 0 Likes on 0 Posts
Default Machine Screws

I am in need of a couple panhead philips machine screws for my 9009 alloy shark heli. Imeasured the screw with my calipers and came up with the following approximate dimensions. I was hoping someone could refer me to a vendor that would carry this size screw.

Diameter: 1.4 mm
Length: 3.5 mm
Thread count: 56-64 threads/inch (counted 7 or possibly 8 threads per 1/8", which equals 56 or 64 per inch)

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.