Go Back  RCU Forums > RC Helicopters > RC Helicopter General Discussions
Reload this Page >

500 metal tail drive assembly

Notices
RC Helicopter General Discussions Discuss RC Helis here. Nitro, gas, turbine and any make, model or brand not having its own specific forum below!

500 metal tail drive assembly

Old 09-12-2010, 02:25 PM
  #1  
RC RedHots
Senior Member
Thread Starter
 
RC RedHots's Avatar
 
Join Date: Oct 2009
Location: Siler City , NC
Posts: 112
Likes: 0
Received 0 Likes on 0 Posts
Default 500 metal tail drive assembly

Hello All

Question: EXI or Trex 500 has anyone ever had a metal tail drive assembly that the screws have stripped out?

I was wondering if anyone has cross drilled and just used 2 screws and 2 lock nuts in place of the 4 screws.

The side plate screws in front of the bearing/s

I am not 100% sure and it looks like it will clear the belt (belt drive).

Any reply welcome!

Thanks RCREDHOTS


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off


Thread Tools
Search this Thread

Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service - Do Not Sell My Personal Information

Copyright 2018 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.