401 9250 servo HELP!!!!!!!!!!! tail problem
 

I had a 401 with the 9252, my delay was set at 0 and gain was set around 70%, but since ive started using the 401 and the 9250 which runs a little slower 9252-0.07sec /9250-0.11 i cant figure out whats the problem with my tail in HH it will wag back and forth and sometimes it will go a full 90deg and hold for a while and then back to wagging, and when i switch to non-hh mode the tail spins to the left.
CAN ANY ONE HELP ME WITH THE DELAY SETTING AND GAIN SETTING FOR THE 401 GYRO AND THE 9250 FUTABA SERVO

RE: 401 9250 servo HELP!!!!!!!!!!! tail problem
 

If you want some good advice get you a 9253 or a 9254, set DS Mode to ON and you will have a worry free tail.

RE: 401 9250 servo HELP!!!!!!!!!!! tail problem
 

I second that. They 9253 and 9254 are made for that gyro.