RCU Forums - Need Servo help

RCU Forums (https://www.rcuniverse.com/forum/)

- RC Helicopter General Discussions (https://www.rcuniverse.com/forum/rc-helicopter-general-discussions-129/)

- - Need Servo help (https://www.rcuniverse.com/forum/rc-helicopter-general-discussions-129/3899415-need-servo-help.html)

Hi All,
I have a question and need some advice. I have a new Raptor 50. I am beyond training gear but just. I have handful of various servos. I need help in deciding which servos to use where. I have a GY401 with 9254 servo so my tail is covered. I will list the servos I have below. Any advice is greatly appreciated.

3-Futaba 9202 .22sec 69oz (this differs from their website but this is what the package says)
2-Futaba 9203 .11sec 76oz
2-Hitec 625MG .18sec 76oz
12-Hitec 425BB .21sec 46oz

Thanks in advance

Chuck

RE: Need Servo help

I'd get one more 9203 and use those for the cyclic; they are fast and have power too. Use a 625MG for throttle then, as its the next fastest.

Or you could use the 9202s for the cyclic, then a 9203 for the throttle.