RCU Forums - tail servo setup

RCU Forums (https://www.rcuniverse.com/forum/)

- RC Helicopter General Discussions (https://www.rcuniverse.com/forum/rc-helicopter-general-discussions-129/)

- - tail servo setup (https://www.rcuniverse.com/forum/rc-helicopter-general-discussions-129/9251723-tail-servo-setup.html)

rc-jj

11-13-2009 06:05 PM

tail servo setup

on the setup advice for the tail servo it is suggested to have servo horn at 90 degrees to horizontal - i have tried every servo horn and still cannot get any of them to be right on the money . I think you are not supposed to put any trim on rudder servo (i am using a gy401), so if servo arm is a little off is that o.k?

emrecozel

11-13-2009 08:20 PM

RE: tail servo setup

What kind of radio do you have?You have to adjust some change in the Gyro sens menu.

rc-jj

11-15-2009 11:00 AM

RE: tail servo setup

i have a dx6i ...

noobflyer01

11-15-2009 12:44 PM

RE: tail servo setup

Quote:

ORIGINAL: rc-jj

on the setup advice for the tail servo it is suggested to have servo horn at 90 degrees to horizontal - i have tried every servo horn and still cannot get any of them to be right on the money . I think you are not supposed to put any trim on rudder servo (i am using a gy401), so if servo arm is a little off is that o.k?

If you cant find 90 on any of the horns you have you can use SUBTRIMon RUDDER to get to 90. your radio will remember that the subtrim is neutral.

All times are GMT -8. The time now is 08:15 PM.