tp777fo

My Feedback: (28)

Thank you

c_makhija

Hello Tom,

From where did you get the pilot and what make and size?

Regards Chatty.

tp777fo

My Feedback: (28)

Warbirdpilots.com.

1/4.5 size (15in)

Getting close?

Tom

c_makhija

Thanks Tom,
Done a fair bit of work last 4 months, still lots to do. Thinking of flying her in primer, need to get her airborne now.
Do you find the rabbit thrust adequate?

Regards
Chatty.

tp777fo

My Feedback: (28)

RABBIT will work fine. That's what use off of grass.

c_makhija

Thanks Tom, will go with the Rabbit. It’s just that we fly in high temperatures here.

tp777fo

My Feedback: (28)

Don't think any bigger motor would work because of small diameter tailpipe. I looked at using a Jet Central Lynx (30#) but tail pipe was too small.

sskianpour

My Feedback: (2)

Would anybody per chance know where I could get a complete Avonds (preferable) or other similar sized Fouga 1/4.5-1/5.5 kit? I realize Aviation Design stopped and so did Avonds so am super sad about it.
Please let me know with a DM. Thanks everyone!
Shaz

tp777fo

My Feedback: (28)

Check with PA. Last time I spoke with him he had 1 Fouga kit left.

David Gladwin

I had an email from Philip this morning, he sold the last Fouga kit two months ago !

tp777fo

My Feedback: (28)

What a great kit and fabulous flying airplane. I love the way mine flies, it's so very graceful. Hate that it is no longer produced.

DUCMOZ

There is a company out of Israel that sells an arf version that seem to be pretty good. There is a thread somewhere in RCU for it.

ambaron

For getting the Fouga Magister ARF you can send Email to : [email protected].

sskianpour

My Feedback: (2)

Tom can you get a hold of me please, my Direct Messages are broken or I am and am struggling to get a hold of you.
Paging Tom Perry to the courtesy phone lol

Shaz 303-482-5004

sskianpour

My Feedback: (2)

PM sent but not sure it is going through to you Tom?

tp777fo

My Feedback: (28)

Check your email.