Old CB Electronics telemetry with older JetCat ECU
#1
Thread Starter
Join Date: Jun 2006
Location: Gold Coast, Queensland, AUSTRALIA
Posts: 1,469
Received 26 Likes
on
24 Posts
Old CB Electronics telemetry with older JetCat ECU
I have been flying a JetCat 180Rx since 2013 using with it a CB Electronics telemetry unit from the same era. Today I decided to test everything for an upcoming event - no telemetry. I have another one of the CB units, but it also does not work. The receivers are bond properly and everything is working fine. The JetCat starts and runs 100% too.
All that I can see is a very small yellow LED on the CB unit and it is flashing rather quickly.
Any ideas?
Thanks,
JanR
All that I can see is a very small yellow LED on the CB unit and it is flashing rather quickly.
Any ideas?
Thanks,
JanR
#2
Thread Starter
Join Date: Jun 2006
Location: Gold Coast, Queensland, AUSTRALIA
Posts: 1,469
Received 26 Likes
on
24 Posts
All sorted out. Dirk from CB Electronics got onto it straight away - fantastic. Must say our hobby is only as reliable as the backup we get from our suppliers and CB Electronics have just joined other top suppliers in my book.
Thanks again Dirk!
JanR
Thanks again Dirk!
JanR