PowerBox Royal - Initializing Process
07-09-2009 | 12:10 PM
#1
Thread Starter
My Feedback: (24)
PowerBox Royal - Initializing Process
When initializing the transmitter/servos (using a PowerBox Royal) is there a way to initialize a 2-position switch/channel ? Like a switch for retracts ? The initialization process is asking for the Center, Left and Right positions. Thanks. Bob
07-09-2009 | 02:08 PM
#2
RE: PowerBox Royal - Initializing Process
If the channel you are trying to initialize is +100 -100 you can initialize it from another +100 0 -100 channel and leave it at that, ie elevator or aileron.
m
m
07-09-2009 | 05:18 PM
#3
RE: PowerBox Royal - Initializing Process
Like Mick says use another Rx channel with a three pos switch to initialise the channel you want to use and then swop it back
Dave
Dave
