Some time ago, I downloaded a very comprehensive set of instructions describing BVM's method of installing a canopy into the canopy frame. It was done in pieces. I have searched the BVM website (Hints and tips) but I can't find the article. Does anyone have a copy?. It seemed like a good way of doing this tedious job.


Regards

Tom it depends on what kit you have. On a bandit it is cut in 2 pieces. On my F86 and F100 I had to cut the frount section in three pieces after I cut it to fit the bow to make a nice fit. Good luck Dan Avilla

Hi Dan,

Mine is an old one piece wing F86. It would require it to be done in four pieces, (rear, front left, front centre and front right.
I had the instructions but lost them. I would like to get another copy. It was very comprehensive with lots of photos. It was on a BVM F4 I think.

I could probably do it by memory but would like to be sure.

Thanks for your help
Regards