Elevator trim on Comp. Arf Classic Lightning
08-23-2010 | 02:19 AM
#1
Thread Starter
Member
Joined: Dec 2003
Posts: 46
Likes: 0
Received 0 Likes
on
0 Posts
From: , DENMARK
Elevator trim on Comp. Arf Classic Lightning
Hi Guys,
How much (if any) elevator trim do you have applied to Your Comp. Arf classic Lightning ?
I have checked cg serveral times and find it spot on (according to manual) - but i still need to apply approx 4 mm up trim.
I have also tried to move cg further and further backwards until the plane becomes very sensible to elevator input with no change to trim.....
What's your experiences ?
/Anders
How much (if any) elevator trim do you have applied to Your Comp. Arf classic Lightning ?
I have checked cg serveral times and find it spot on (according to manual) - but i still need to apply approx 4 mm up trim.
I have also tried to move cg further and further backwards until the plane becomes very sensible to elevator input with no change to trim.....
What's your experiences ?
/Anders
08-23-2010 | 02:59 AM
#2
RE: Elevator trim on Comp. Arf Classic Lightning
Anders
I had around 2-3mm up on my Classic Lightning. I like the stock C of G, some people move it back a little
Dave
I had around 2-3mm up on my Classic Lightning. I like the stock C of G, some people move it back a little
Dave
08-23-2010 | 03:46 AM
#3
RE: Elevator trim on Comp. Arf Classic Lightning
yep correct
my Ultra lightning needed also about 2-3 mm up (measured inside of elevator) to fly Strait.
CG was on mine as far aft as possible
my Ultra lightning needed also about 2-3 mm up (measured inside of elevator) to fly Strait.
CG was on mine as far aft as possible
