JR DSM question
 

I am thinking about finishing my 103" ME163 with a turbine hidden in it. My question is can you bind two Rx's to the same Tx? I want to hide a Rx and servo for brake function in the fall away take-off dolly.

Roy

RE: JR DSM question
 

Yes.

When you bind them, just have both rx's on and the bind plugs in

RE: JR DSM question
 

Thats not true, you can bind one, turn it off and bind the other, just make sure the recievers are the same, dont try to mix a DSM2 and a DSMX for example.

RE: JR DSM question
 

yes it can be done where you could put your brake on a slider or switch that you could activate after separation..

DSM2's are bound at the same time because the receiver accepts the GUID, which is generated at startup when the bind button is pressed.

I dont know on DSMX , as the two way interaction may require separate binding sequence since the transmitter is listening for a ping from the receiver during bind.

RE: JR DSM question
 

Sorry but thats not correct.

The GUID is fixed in the firmware of the transmitter. On module based systems the last two digits are 00 (no model match) and on native systems the last two digits indicate the model memory to make the GUID of each memory location unique thus giving you model match.

It's not generated when the bind button is pressed.

DSM2 or DSMX you can bind one at a time.

Think about it, if a new guid were generated when the bind button were pressed, what happens when you do a range check? :)

RE: JR DSM question
 

On DSM2 you can do it either way, one at a time or multiples at once. Your choice.

RE: JR DSM question
 

There you go from the Horses mouth :D

RE: JR DSM question
 

For the record, I already said the right answer! :D

RE: JR DSM question
 

Just sidetrack a little seeing as you've already got the answer you were after:)

What Komet are you building? a Joe saettia? Pic's!!!

Thanks
dave