Spektrum DX18 Stealth Crashes
 

HI all ,need to get my new Dx18Stealth up and running for Florida Jets.
Was programming my T-33, I sold my DX 18 gen 2, which had my T-33 program in it and was not transferable to the new Stealth.
After I finished doing the program tonight, I started to put in some Warnings and locked up the transmitter, it is stuck, see pic.
Need helphttp://www.rcuniverse.com/forum/atta...mentid=2145522http://www.rcuniverse.com/forum/atta...mentid=2145523
Rcpete

Did you try holding down the roller as you turn on the radio to get to the system setup?. Just a thought

I switched to JR DMSS after I purchased DX18 Stealth....I now use my DX 18 as a $900 foamie TX. I had too many problems with it and did not trust it for my jets.

Hi Pete
turn on the tx wait about 10sec then hold down the roller button for about minute, the tx should reboot. You will prob lose the program after it restarts.
Vin...

You can transfer files between the G2 and Stealth assuming they are the same firmware version

Thanks Bob. your a life saver, I held down the roller as I turned on the radio and removed the warning.
Thanks Rcpete

Glad to help Pete. I've already been down that road

Stealth had range problemd also