JR XG14 - Turbine Shutdown
Can anyone help with how to programme the JR XG14 so I can shut the turbine down via one of the spare switches. I just want it to flip the throttle trim to the lowest position so I don't have to wait for it to transit from top to bottom.
thanks |
You can do it in the Function list Thro Trim and chose a switch for throttle cut. Set Thro trim memory for one touch. There are choices!
|
Originally Posted by Dave Wilshere
(Post 12228937)
You can do it in the Function list Thro Trim and chose a switch for throttle cut. Set Thro trim memory for one touch. There are choices!
Cheers |
Mine is set up with a kill switch. Was easy to do.
|
Describe exactly what you require, switch you feel safe using and we will walk you through.
Dave |
Thanks Dave, I would like to use the mix switch (top left rear) to flip the throttle trim between full up and full down
|
Function List
THRO TRIM Go to THRO CUT. First SW SEL and select MIX SW on page 3 and make the 1 black. Press L (List button-second button down on left of TX, to go back) You should see OFF or ON with the switch flicked, where it says ACT wind that down with the roller to -25%. Come back to the normal screen and ensure the throttle trim is in the middle, now if you go to monitor to watch what is happening you will see the throttle trim jump from -100 to -125, when you lean the Rx doi the off with the switch thrown, idle with it back (normal position) and use the throttle stick for full power. With the switch on the turbine will stop, you can set a delay TIME LAG of 1-1.5sec so if you knock the switch you can hit it back and the turbine won't stop Dave |
Many Thanks Dave, works a treat.
|
All times are GMT -8. The time now is 02:36 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.