Jetronics dual valves
 

Is it possible to delay the extension of the gear leg by 2 seconds with the jetronics dual valve? The valve is set to factory default. I know I can put a restricter in the line to slow it down a bit but would prefer for it to just delay and then come down with authority. The only reason I ask is the door and gear are very close to the same time and I cannot change the door.

Hi.
What I've done is to put the gear on one valve and doors in other valve, and secuence them to my needs, using a secuencer or extra channel in transmiter.
Regards.

I do have them of two valves as you mentioned. I am using the sequencer in the radio for the doors. I was hoping that using the dual valve with no sequencer it would be possible to pause the gear for a brief moment to give the doors some extra time. I cannot speed them up. I can use an adjustable restricter to do this if needed.
Thanks for the response.

Then with the Tx secuencer you should be able to control the signal to the gear and door valves independently with the appropiate delays in each one, for the up and down secuence.
At least thats what I do with my Tx. If your Tx can´t do that, then I believe the only way would be with external adjustable restrictors.
Regards

Slow the channel down?

Not to hijack the thread but, does any one knows how to fix a Jetronics single action valve that is not turning on when power is applied.

Tks.

Thank Dave, you are always so helpfull, I will try that, if it doesn't work then. I will take a crack at it and will open it to take at look at its guts :)