JP Hobby Gear controller help
About to get my sledge hammer out and flatten this thing. It is stuck in V2 (doors open gear down, doors close) how to I get in V1. Doors open gear down doors stay open.
|
i thought those were two distinct versions... v1 "process" and v2 "process" i did not think one unit did both...
|
Mine is the multifunction version. It was working but I needed to adjust servo travel for door opening/closing. Now it thinks it is V2.
|
Long press ( 2 sec) of the Mode button to enter the functions
Then short press of the Mode button to move from function to function Function 1: Reversing: When the A or B light is flashing, press the + / - button to set the servo CW and CCW direction function. Function 2: End Points: When A+B flashes alternately or C+D flashes alternately, press + / - button to set the throw of the servo. A+B is one end point, C+D is the other end point Function3: Mode: When the C lamp is flashing, it is V1 mode. (doors stay open), press the + / - button to switch to D (V2) mode When the D lamp is flashing, it is V2 mode. (doors close gear down), press the + / - button to switch to C (V1) mode Once in a mode, do something within about 5 seconds or you'll have to start over And, yes, it is worthy of a sledgehammer https://cimg2.ibsrv.net/gimg/www.rcu...7b6e6f34b4.jpg |
Ran batteries down doing the hokey pokey. Will charge and try again tomorrow.
|
Before you take a hammer to it, try setting the doors up with your transmitter only. Probably easier than what you've been doing.
|
Well I finally got the little F'er. Whata royal pain in the a double. At least I can not get this thing back together.
|
All times are GMT -8. The time now is 05:33 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.