Who wants to build a turbine?
1 Attachment(s)
Who wants to build a turbine?
i do i do johnny |
Who wants to build a turbine?
1 Attachment(s)
Ok lets add some turbine blades Compressor Diffuser shaft and some Ceramic bearings.
|
Who wants to build a turbine?
1 Attachment(s)
Next lets add a bearing tube
|
Who wants to build a turbine?
who's kit?
|
Who wants to build a turbine?
Where are you going with this? Can I do it with a pair of scissors and coffee cup? I've got a couple of turbochargers in the junk pile. What do I need, and how much will it cost? Can you run it with an old lap top? A pocket calculator? I'd build one just to listen to it spool up.
Gordy |
Who wants to build a turbine?
1 Attachment(s)
Hi john
It’s a kj-66 so it will fall under the home built waiver. Hi Gordy “I've got a couple of turbochargers in the junk pile” Yes gordy many people have built turbine jet engines from turbochargers (jpx Sophia) Old lap top? A pocket calculator? Why not? I have found most jet people to be above average I use an old laptop for data acquisition on all my turbines. This is a photo of what may be one of the most important points of assembly fitting the bearings to the tube So that the outer race has no run out. The o ring method saves a lot of precision man hours but also adds other concerns. |
All times are GMT -8. The time now is 04:16 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.