Jim Fox 48" Hawk help needed
 

Hi I have an old kit of the Jim fox Hawk kit 48" span.
I am going to convert it to turbine, wren 54. I have got in touch with Jim and since purchased new intakes, firewall and fuel tanks. I have a few questions, mine is the foam wing version with the single pivot elevators. I need help with jet pipe and contruction of the ducting, firewall position and tanks etc.
Also any other tips on were more strength would be needed.
Has anyone done a conversion on the original DF version?
Any help would be appreiciated.

Russ

RE: Jim Fox 48" Hawk help needed
 

Is this the epoxy glass fuselage and foam wing version?

RE: Jim Fox 48" Hawk help needed
 

Hi Yes its epoxy fuzz and foam wings, its 53" span and not 48 as i 1st said.
Can you help?

Russ

RE: Jim Fox 48" Hawk help needed
 

If you take a look at the the FOX Composites Hawk thread, there will be a lot of info in it that could help.
The new Fus is very similar to what you have.

PM me for more info if you wish.

Paul

RE: Jim Fox 48" Hawk help needed
 

Hi Paul, tried to PM but cant for some reason. My email address is

[email protected]

Russ