bvm m1 balsa kit c.g
 

can anyone help me with the c.g on a early short boomed bobcat and also control movements thanks regards jonathan

RE: bvm m1 balsa kit c.g
 

There should be two small holes at the bottom of the booms for CG. Get about an inch of up and down on the elev with 20% expo. Alireons are very strong, so get .75, .5 and .25 of an inch for tripple rates. Rudder one inch...

RE: bvm m1 balsa kit c.g
 

thanks ehab there are no holes in my booms the booms were taty when i bought it so i have painted them and have lost the holes does any one out there flying one no where the hole should be from the front of the boom thanks jonathan

RE: bvm m1 balsa kit c.g
 

You don't need no stinkin' expo....

Raf

RE: bvm m1 balsa kit c.g
 

And were YOU flying with EXPO today master Jedi:)

If I recall correctly, I balanced my standard BC at the leading edge of the main Alu. tube...But please check witha BVM rep first...