RCU Forums - Need linkage advice on Tams dual axis thrust vector nozzle

RCU Forums (https://www.rcuniverse.com/forum/)

- RC Jets (https://www.rcuniverse.com/forum/rc-jets-120/)

- - Need linkage advice on Tams dual axis thrust vector nozzle (https://www.rcuniverse.com/forum/rc-jets-120/9308935-need-linkage-advice-tams-dual-axis-thrust-vector-nozzle.html)

DrScoles

12-06-2009 06:56 PM

Need linkage advice on Tams dual axis thrust vector nozzle

I've searched like crazy, seen some good pics on installation, but I can't see where the pushrod attaches to the two points on the nozzle. Its a threaded bolt that sticks out. Can someone post a pic of their linakge??

Thanks, Mike

carbunkle

12-06-2009 11:34 PM

RE: Need linkage advice on Tams dual axis thrust vector nozzle

1 Attachment(s)

This is not a tam's but the linkage is the same I think. I made this set up a few years ago for a stock rookie pipe. I replaced the metal rods with carbon fiber ones but don't have a good pic of that. Works great!

All times are GMT -8. The time now is 06:23 AM.