savage wont go
#1
Junior Member
Thread Starter
Join Date: Feb 2003
Location: kelso,washington
Posts: 5
Likes: 0
Received 0 Likes
on
0 Posts
savage wont go
Sorry guys im new to this but anyway everything seems everythings going fine then all sudden it will barley move when I hit the gas motor is fine seems like everything else is fine but it hardly moves I tightend the slipper on the spur and that did not help any quick steps to see whats wrong?THANKS
#2
Senior Member
My Feedback: (3)
Join Date: Feb 2003
Location: Mountain View, CA,
Posts: 262
Likes: 0
Received 0 Likes
on
0 Posts
savage wont go
Do you mean that when you are trying to accelerate it just winds out and doesn't go anywhere?
Does it smoke a lot when this happens? Is the flywheel spinning but not the clutchbell?
It could just be a carb adjustment. Have you changed any of the needle positions?
Does it smoke a lot when this happens? Is the flywheel spinning but not the clutchbell?
It could just be a carb adjustment. Have you changed any of the needle positions?
#3
Member
Join Date: Jan 2003
Location: Whittier, CA
Posts: 90
Likes: 0
Received 0 Likes
on
0 Posts
savage wont go
Newer savages seem to be having a problem with the one way in the transmission. check out page #27 in the manual. i think hpi will replace it if you send it in but im not sure. call them up. goodluck.
#4
Senior Member
Join Date: Mar 2003
Location: Belgium - Europe, BELGIUM
Posts: 752
Likes: 0
Received 0 Likes
on
0 Posts
savage wont go
Yes, does your flywheel turn ? If yes, it can be a carb. problem ! Does the carb open all the way ? I had that same problem with my savage. If not loosen the carb and turn it a little.
This schould do the trick.
This schould do the trick.