RCU Forums - Pull Start

RCU Forums (https://www.rcuniverse.com/forum/)

- RC Monster Trucks (https://www.rcuniverse.com/forum/rc-monster-trucks-160/)

- - Pull Start (https://www.rcuniverse.com/forum/rc-monster-trucks-160/1864202-pull-start.html)

Sypro

06-01-2004 02:07 PM

Pull Start

The pull start on my XTM Mammoth keeps sliping, i cleaned the 1 way and the 1 way shaft with rubbing alchol and wiped it down and it still slips!!!! WHAT DO I DO????? Are there any alternatives? Who elese is having this problem?

R/C Madman

06-01-2004 03:25 PM

RE: Pull Start

The one-ways ware out sometimes and the only thing you can do is replace it. Also your starter shaft can get worn down and that may need replacing as well.

Sypro

06-01-2004 04:24 PM

RE: Pull Start

I just go it, i only ran like 12 tanks out of it so far.

R/C Madman

06-01-2004 05:09 PM

RE: Pull Start

It could be a bad one-way. I would send an email to XTM support and see if they will send you a new one. I have gone through some one-ways pretty fast in the past but, not sure if it was within 12 tanks or not. You can get a Yank eliminator but, I have not had very good luck with them lasting either.

All times are GMT -8. The time now is 04:59 AM.