Will this fit the savage engine?
 

Will this fit the savage engine?
 

hey landshark go with the mip 7.5 kyosho clutch its better and less expensive thats what im gonna get for my 8 port when i get it that is just my opinion but hey thats what were here for catch ya later :p

Will this fit the savage engine?
 

thanks Knoxville, but i want a 3 shoe clutch

Will this fit the savage engine?
 

Yes it will, but you will have to move the engine back a little the Ofna bell is much bigger than the HPI. Kyosho also makes a 3 shoe flywheel that is thinner than the Ofna uses the same shoes. No mods needed for Kyosho.

Will this fit the savage engine?
 

Kyosho?

give me a link from tower please.

Will this fit the savage engine?
 

3maxxman, please tell me everything that i need to buy.

you said ofna bell is bigger than hpi, and Kyosho has thinner

fly wheel. so what? use ofna bell and Kyosho fly wheel?

please list everything that i need to buy. i am a noob

thanks

Will this fit the savage engine?
 

Sorry, it's the Mugen that is smaller not the Kyosho.
Complete flywheel is not instock at tower but they do have the pieces. It will cost about $4 more than buying the set. Here are the links.
Mugen parts
Ofna clutchbells (almost to the bottom)
Tower does not carry any aluminum clutch shoes. If you really want your clutch to grab and launch hard get aluminum clutch shoes. Search ebay for "aluminum clutch" they are $24.95 list and come with 2 sets of springs.

Will this fit the savage engine?
 

I really appreciate for all the help.

now i know what a complete clutch set contains.

i bought the ofna clutch bell form my LHS. it fits perfectly

Will this fit the savage engine?
 

Hey, not to sound like a know it all, but here is a link to the aluminum clutch shoes I use in my Savage that I bought from Tower Hobbies. They don't have the springs in stock, but I just use a set I had from another 3 shoe designs.

These shoes rock!

http://www2.towerhobbies.com/cgi-bin/WTI0001P?&I=LXCNL9

Also, when Tower receives the following flywheel, it's mine !
http://www2.towerhobbies.com/cgi-bin...?&I=LXPF82&P=K

Will this fit the savage engine?
 

will the small fan flywheel reduce or delay or slow the accleleration?

Will this fit the savage engine?
 

I'm sure it will cause some drag, but I doubt it would be noticeable.

It will however get a little air flowing over the engine where there wasn't any before, like while in idle while tuning etc.

My heli motor runs a large fan on the flywheel to help with temp problems. Granted, the heli motors don't rev like the Savage.

clutch
 

is anyone using diffrent type clutch shoes that are alot better then the stock, or do I need a three shoe clutch system? I love my savage, but the clutch system could be better. Oh well, love it anyways....
Larry

Will this fit the savage engine?
 

I would go with the aluminum 3 shoe

clutch
 

adamb, do you have part no. that will fit, or is there like a complete set that can be purchased? Thanks

Will this fit the savage engine?
 

Will this fit the savage engine?
 

Have you guys heard of the FIORONI 6 shoe sliding clutch kit?

Will this fit the savage engine?
 

I'm using the Mugen clutch setup and an Ofna 16T clutchbell on my 8port Savage.I'm thinking about getting those Kyosho clutch shoes now that i've seen them.They look like they'll work better that the ones i'm using now

Will this fit the savage engine?
 

Those should fit perfect.a friend of mine has an 8port and hes running a duratraxx 4 shoe set up, The flywheel on the duratraxx kit and Kyosho flywheel are the same thickness.Are you talking about the BLUE colored kyosho flywheel for mp 7.5?