Tmaxx at very high rpm when idleing.?huh?
When i start my tmaxx 2.5 it idles at very high rpm's. I mean very high rpms!. It is a new carb and i just put a traxxas 2.5 pullstart on it. Would that have anything to do with it? Which needle do i work on to lower the rpms when idleing on the truck? thanks
|
Tmaxx at very high rpm when idleing.?huh?
Adjust the LSN to get the idle down.....
|
Tmaxx at very high rpm when idleing.?huh?
DLOCK said it all..adjust the LSN, I replaced my carb a few weeks ago and that was the first thing I adjusted, the idle came right down...
|
Tmaxx at very high rpm when idleing.?huh?
yes but make sure you open it not close it!! Just turn it counter clock wise half a turn, if its still high udjust the idle screw by turning it 1/8 of a turn out, or until the idle comes down!!
|
Tmaxx at very high rpm when idleing.?huh?
Err.. I'm surprised no one said anything about the set screw, which is probably the culprit
Also.. less probably, maybe the carb hase a hole somewhere? Maybe the radio's throttle setting is in "reverse servo" position and its at full throttle during idle? :) J/K The LSN can definitely have a big impact on idling, but if your sure its tuned right and it still idles high, I'd take a good look at the set screw! Adjust the LSN to have a good low range, not to get a good idle! ram |
Tmaxx at very high rpm when idleing.?huh?
ok..thank you all for the quick replys. I will try everything that you guys told me..bye
|
All times are GMT -8. The time now is 09:33 PM. |
Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.