Rick_grff

Need help I replaced. My diff gear with an aftermarket one. I put all the the little balls back and tightened them down. I put the gear back in the transmission and installed it. I didn't mess with the slipper clutch or the spur gear I left them on when I took it apart. So now trying to drive it. The drive is slipping. Any help? Thanks Rick

D3MON

the ball diff should be set to a specific setting, did you adjust it per manual?

Big Alice

Page 8 https://www.manualslib.com/manual/90...?page=8#manual

Rick_grff

Thanks Big alice and D3. I didn't put the left side drive spring in. In fact I don't remember taking that section apart at all to where I could loose it. Time to get on my hands and knees and checking the floor.