throttle servo for jato ??
 

my stock servo has play in it an id like to upgrade to a ball bearing servo for the throttle . something with a quicker responce an pull .
i have a hi tec 645-mg for my steering would this be good for the throttle too ?
im using a futaba 2pl tx an a r142je rx

RE: throttle servo for jato ??
 

[link=http://www2.towerhobbies.com/cgi-bin/wti0001p?&I=LXN583&P=0]Hitech HS525BB[/link]...no need for metal geared on throttle/brake

RE: throttle servo for jato ??
 

if you have the 645 id get the 625 for throttle. i hate plastic gears ! if you plan on using good brakes then get the 625 it will be good.

RE: throttle servo for jato ??
 

I use a JR 590m. It has more than enough torque for wheel locking brakes and is fairly quick. It's a good deal for $40 and will also make a decent backup steering servo. I have had bad experiences with Hitec servos so I personally don't buy them anymore. I had a 605 fail after just a gallon of fuel, and I went through three 525's on throttle that all started glitching after about 15 minutes of use. Between planes and cars I have owned about 20 JR servos and they have all been great.