Help Quick
 

I have a nitro evader st, havent ran it in a wihle. would like to run todya, spent 2 days putting it back together and getting it set up.

I think my slipper pad is worn, i have many pads but i dont know which ones are good or not, i have 2 white ones from i think the Rc10gt, and a couple blue DTX ones..

my question is is there a way to make any of them work? no matter which ones i put in there it doesnt move the wheels, it just spins the spur even when i use my hand, but when i spin the thing behind the spur it moves the wheels, its all the way tight

any way to make them work?

RE: Help Quick
 

Sounds like theres somthing else in the tranny giving you problems.

RE: Help Quick
 

why, it all works fine, it doesnt even spin the part you put the slipper pad on, its slipping at the spur not the diff's

RE: Help Quick
 

Is this it? i have the stock stuff i think.

http://www2.towerhobbies.com/cgi-bin...?&I=LXDHJ9&P=M

but under comments it says something like must use the hard anodized slipper plate?

why?

I think my stuff is still stock.. is there a different slipper pad or will these work?

RE: Help Quick
 

i replaced the plate on the spur gear, and lightly sanded the slipper plate and hte spur plate and hte pad, with 80 grit sand paper to try to get it to grip..

i think i got it, but its POURING down rain, really hard.. figures.