Ack!! Jato Problem!!
 

So here's the dilly,
I got the battery holder from the guy, Im excited! I plug it in, turn the car on then the receiver, wiggle the remote and...Absolutely nothing, no jitters no...nothing at all...WHHHYYY?!?!?!
Could it be the receiver or the remote?
I havent checked yet whether the receiver gets power from the on/off switch yet but I dont think that could go bad could it?...anyways...
HELP!!!
~Wendell~

RE: Ack!! Jato Problem!!
 

New batteries in remote? Your crystals in place firmly?

RE: Ack!! Jato Problem!!
 

is it an aftermarket batter pack and reciever? if so could be plugged in backwards or your servos could be thats what i did when i got my hi-tecs ROFL then i was like DUH there backwards.
But like Blind said could be crappy crystals or dead batteries or different crystals????

RE: Ack!! Jato Problem!!
 

same crystals, Dunno how tight in the thingies they are, Ill check that. and the batteries are freshly charged rechargeables..So I dont think that'd be the problem.
Ill check the crystals though, and also I cant put in the connecter backwards cause its got a little slot in it so you cant put it on any other direction.

RE: Ack!! Jato Problem!!
 

oh well maybe its a pinched wire happened before just buy and new receiver and battery pack if it doesn't start to work and did u run it throgh ur switch

RE: Ack!! Jato Problem!!
 

The on/off switch is a notorious place for failure. I think most people wire in a deans connector in place of a switch. It's a cheap insurance policy against a runaway due to a 19 cent switch that can't hold up to the constant abuse.