xkwizt

ive wasted 3 cans practicing and trying to get a fade from red to orange to yellow

so friggen hard is there any tricks to getting it right? i even made my own stencil where there were holes going from large to really small and it turned out ok BUT it wasnt a fade lol

is it possible or am i wasting my time?

evomac

Doing a fade with cans is very difficult. That is one of the main benefits of a airbrush over a can, much more controlled with the air pressure. My best suggestion to you with using a can is put it in warm (not hot) water and heat the can up a bit. This will give a much finer spray. Hopefully that will help a bit.

Regards,

-Evo-

xkwizt

ill get an airbrush 2morow, 20 bucks from the craft store. i still wont know how to fade it so if u can give me some instructions as a guide it will be good.

rcxboy

Just look on the internet, there are plenty of tutorials.
http://www.rctech.net/articles/paint...ntedmyst.shtml
http://www.cptnet.com/ken/faq.html

xkwizt

I LOVE YOU RCXBOY !!! i couldnt find these ><

venom racing

if you want to use a can you could try and take a rag and lay it downand fold it in hlaf while holding up the half you folded over. the spray will go under the towel and creat a fade if its done right

xkwizt

thanks venom ill try it out now

venom racing

sure it worked for me. lol i hope that the little pictures that i made that in like 5 minutes in photoshop.