RCU Forums - Which servo(s)

RCU Forums (https://www.rcuniverse.com/forum/)

- RC Pattern Flying (https://www.rcuniverse.com/forum/rc-pattern-flying-101/)

- - Which servo(s) (https://www.rcuniverse.com/forum/rc-pattern-flying-101/11375690-servo-s.html)

I have previously used JR then Futaba servos, most recently 9650 (2) on elevators, 9154 on ailerons and 9156 on rudder.....

I now have a Griffin to fit out. Request recommendations.......

Is the extra expense for BLS worth it? If so which ones?

I don't necessarily have a preference for JR or Futaba (or Hitec) but not Airtronics. I wish to use a standard size aileron servo, not a low profile (not 9154) because the hole in the wing is for a standard size (I can enlarge it if I must....)

The servo's will be commanded by a JR1221 receiver (so no Futaba SB) and powered by a regulated 5.9V.

Thanks in advance for your suggestions! :D

RE: Which servo(s)

futaba BLS
rud 451 or 351
ail 551 x2
elev 153 x2

RE: Which servo(s)

Composite ARF valiant.

Rudder = JR 8511
Elevator = JR 8231 X 1 (pull/pull). Would have used 9411's if stab mounted.
Aileron = JR 9411
Throttle = JR 362

RE: Which servo(s)

AUS50518
Take a look at post under Electrid RC post #21 New Griffin . These were servo we use and they worked great. There all the hardware list htat's in plane.

Jr