|
Loop
Hello
New design by Christophe Paysant Le Roux to start in F3A in electric and IC version The fuselage will be may modify. Christophe thinks it is too high and therefore sensitive in crosswinds, which makes piloting less easy Will be available in scratch built to keep the cost as low as possible. Wings of the prototype were built by CPLR himself. Claude https://cimg1.ibsrv.net/gimg/www.rcu...f6b36450b4.jpg https://cimg4.ibsrv.net/gimg/www.rcu...8ce64999cf.jpg https://cimg7.ibsrv.net/gimg/www.rcu...2979cdb16a.jpg https://cimg8.ibsrv.net/gimg/www.rcu...446ad522b1.jpg https://cimg9.ibsrv.net/gimg/www.rcu...65ec09f803.jpg https://cimg0.ibsrv.net/gimg/www.rcu...0b90c3a641.jpg https://cimg4.ibsrv.net/gimg/www.rcu...5e271dc0d0.jpg |
Hello
Picture of the wings I forgot to post Claude https://cimg0.ibsrv.net/gimg/www.rcu...9e310ac779.jpg |
Hi Claude,
It's quite small at 1750mm, isn't it. What's the idea ?? Brian |
Good question, Brian. Considering the designer, designed for IC and that other thing, oh yeah, electric, the size and reducing cost; I’d say it was being designed around a YS 1.15. I’ll build one from plans, but I’d love to see an all wood, laser cut kit or short kit.
|
Hello Brian
Originally Posted by serious power
(Post 12729761)
Hi Claude,
It's quite small at 1750mm, isn't it. What's the idea ?? Brian The goal is to promote access to competition with a medium-sized, low-budget aircraft. I think this plane can be motorized with 5 or 6s batteries. These batteries can then be used in 10s or 12s if the modeler decides to continue the F3A aerobatics with a 2x2 aircraft. Claude |
Originally Posted by papaone
(Post 12729796)
Hello Brian
As you know, most 2x2 planes are expensive and not affordable for everyone. The goal is to promote access to competition with a medium-sized, low-budget aircraft. I think this plane can be motorized with 5 or 6s batteries. These batteries can then be used in 10s or 12s if the modeler decides to continue the F3A aerobatics with a 2x2 aircraft. Claude |
Hello
Some progress news; Claude Vuattoux completed the modeling of the fuselage after modification of the drawing (lower fuselage) by Christophe. He also designed a new motor cowl. Cowl and canopy are made in 3D printer. Claude https://cimg6.ibsrv.net/gimg/www.rcu...49e33d7704.jpg https://cimg7.ibsrv.net/gimg/www.rcu...2a84b729d7.jpg |
Hello
The fuselage design has been finalized by CPLR. The parts of the kit will be cut by the Ecirtech Company. https://www.ecirtech.fr/ Claude https://cimg7.ibsrv.net/gimg/www.rcu...e4c2ad90ca.jpg |
Great idea memories of Hanno. Get rid of the T cannalizer though.
|
Je k dispozici scratch build, nebo alespoň plán?
|
Any news on the loop?
|
| All times are GMT -8. The time now is 05:30 PM. |
Copyright © 2026 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.