sportflyer-RCU

My Feedback: (35)

Can someone plse advise the torque/speed specs for Futaba S9303 at 6.0V ? The only specs I have is 100oz in and 0.19 sec with no mention of the specified voltage which I assume is 4.8V . Tks

Geistware

My Feedback: (16)

Usually figure about a 25% increase in torque going from 4.8 to 6.0 volts

Bax

My Feedback: (11)

It's only been very recently where Futaba has had ratings for servos used on 5-cell NiCd or NiMH packs. The S9303 was never rated on anything but 4-cell packs. That was the standard.

You can find Futaba servo specs at:

http://www.futaba-rc.com/servos/futm0029.html

sportflyer-RCU

My Feedback: (35)

Assuming that the 100oz inch spec is at 4.8v ,the estimated torque at 6.0V should be approx 124 oz in based on Futaba Servo tables. Tks

Hogrider

My Feedback: (392)

Should we use only 4.8v or can the S9303 use 6.0v also(without any damage to the servo)?