Community
Search
Notices
RC Radios, Transmitters, Receivers, Servos, gyros Discussion all about rc radios, transmitters, receivers, servos, etc.

Acoms Servos

Thread Tools
 
Search this Thread
 
Old 03-25-2004, 01:53 PM
  #1  
petec
Thread Starter
My Feedback: (58)
 
petec's Avatar
 
Join Date: Jan 2002
Location: Beaver Falls, PA
Posts: 2,078
Likes: 0
Received 3 Likes on 3 Posts
Default Acoms Servos

I just bought a Cermark Javelin II (BEAUTIFUL plane) it came with Acoms AS-12 servos installed and I can't find any info on them. All I have found are European e-comm sites that sell them, but no info on if they are any good.

Has anyone had any experience with these servos?
Should I look at them the same as Cirrus servos (throttle only)?
I have found out that the output shaft takes a JR arm. I am contemplating pulling them and replacing them with JR servos.

Ideas? Comments?
Old 03-29-2004, 12:53 AM
  #2  
desert_rat
Member
 
Join Date: Sep 2003
Location: CabramattaN.S.W., AUSTRALIA
Posts: 37
Likes: 0
Received 0 Likes on 0 Posts
Default RE: Acoms Servos

Comment:

Acoms was the previous name for sanwa and then airtronics so you might want to ask them.
Old 03-29-2004, 08:11 AM
  #3  
petec
Thread Starter
My Feedback: (58)
 
petec's Avatar
 
Join Date: Jan 2002
Location: Beaver Falls, PA
Posts: 2,078
Likes: 0
Received 3 Likes on 3 Posts
Default RE: Acoms Servos

I'll have to look into that.

I pulled four of the five and replaced them with JR 517's. The one Acoms I left in is on throttle and it won't run it's range of motion accurately. I think they'll wind up in the Swap Shop.

Thanks for the info.

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off



Contact Us - Archive - Advertising - Cookie Policy - Privacy Statement - Terms of Service -

Copyright © 2024 MH Sub I, LLC dba Internet Brands. All rights reserved. Use of this site indicates your consent to the Terms of Use.