Home Made Y harness
#1
Member
Thread Starter
Join Date: May 2002
Location: Wauchula, FL
Posts: 47
Likes: 0
Received 0 Likes
on
0 Posts
Home Made Y harness
I have soldered in servo extension wire to lengthen servo leads on several models with no problems. My question is, can I make Y's in the same way. Just solder the three sets of wires together with the appropriate ends. Thanks in advance.
#3
My Feedback: (62)
Join Date: Dec 2001
Location: Vineland,
NJ
Posts: 3,856
Likes: 0
Received 0 Likes
on
0 Posts
I agree with MTT
But, still can't figure out why JR only sells one WITH an amplifier. When I asked Horizon if they supplied one without an amp they said no! So I installed a stock JR with amo in my 33% Edge and it works fine. Go figure?