Airtronics RD8000 flaps issue
#1
Member
Thread Starter
Join Date: Jan 2002
Location: Trophy Club,
TX
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts
Airtronics RD8000 flaps issue
I have a new RD8000 radio and I am confused on the flap programming. I have the Flaperon active and have my left wing servo into ch2 and right into ch6 on the RX. All works well the both servos funtion properly as ailerons. But when I try flaps they go up instead of down.
The book says "if the flaps go up change the polarity of the program". Now how does one do that?
I tried flap EPA, but can't get negative values, only 0% to 150%. HELP[][&o][X(]
Mike
The book says "if the flaps go up change the polarity of the program". Now how does one do that?
I tried flap EPA, but can't get negative values, only 0% to 150%. HELP[][&o][X(]
Mike
#3
Member
Thread Starter
Join Date: Jan 2002
Location: Trophy Club,
TX
Posts: 94
Likes: 0
Received 0 Likes
on
0 Posts
RE: Airtronics RD8000 flaps issue
hattend - are you saying I should reverse the flap channel (6?). If I do that it only reverses one of the servos (right wing).
I reversed both that and the ailerons - then the flaps worked fine, but the ailerons were backwards!
Do I need to swap the servos from ch2 and ch6?
Sorry to be thick, but this is driving me crazy!
Mike
I reversed both that and the ailerons - then the flaps worked fine, but the ailerons were backwards!
Do I need to swap the servos from ch2 and ch6?
Sorry to be thick, but this is driving me crazy!
Mike