futaba 3003
#1
Senior Member
Thread Starter
Join Date: May 2002
Location: hervey bay, , AUSTRALIA
Posts: 289
Likes: 0
Received 0 Likes
on
0 Posts
futaba 3003
i have a lot of 3003 servos in various planes. recently though, i seem to be stripping a lot of gears. the servos are not that old and the replacement gear sets seem to be even more brittle than the old. does anyone else have a problem with these servos or is it just me.
#3
Member
My Feedback: (2)
Join Date: Jul 2002
Location: Norman, Oklahoma
Posts: 90
Likes: 0
Received 0 Likes
on
0 Posts
futaba 3003
Same with the 3004s I used that came with my radio. The throttle servo just kinda stripped one day on my trainer. Doesn't make much sense to me, how much torque is on the throttle servo?
Dunked my plane into the ground once , (not bad, flying again the next day) and 2 of the 3004s stripped out. Its like Futaba is making their gears out of paper or something.
Dunked my plane into the ground once , (not bad, flying again the next day) and 2 of the 3004s stripped out. Its like Futaba is making their gears out of paper or something.
#4
Senior Member
Thread Starter
Join Date: May 2002
Location: hervey bay, , AUSTRALIA
Posts: 289
Likes: 0
Received 0 Likes
on
0 Posts
futaba 3003
2 weeks ago stepped back and bumped an aileron, bingo stripped 4 teeth of the output gear. didn't bump it that hard. i can't track down enough spares to keep up. looks like i will be changing the 3003's for something a little more sturdier.