Ndawg232

My Feedback: (2)

So today i am workng on my newest plane the zagi razor, i am all ready to setup the control surfaces, so i plug in the speed control to channel 3 and both the elevon servos in to channels 1 and 2 of my Hitec feather 4 channel servo. I was testing the controls in great surprise realizing that only the speed control was working. I have the right single conversion crystal cause i have flown with this setup before without any problems. I just can not figure out why the control surface servos are not working, they do not even budge or make any noise it is like they are off??? any help would be greatly appreciated, Thanks All!!!