Futaba 9 CHP/ 9 CAP controller question!
10-04-2005, 08:54 PM
#1
Junior Member
Thread Starter
My Feedback: (28)
Join Date: May 2005
Location: Alvin,
TX
Posts: 9
Likes: 0
Received 0 Likes
on
0 Posts
Futaba 9 CHP/ 9 CAP controller question!
I've got a 9 CHP contoller and was wondering if there was any way I could program my controller to do this:
When the airplane lands I want all of the flaps (Ailerons and Elevator) to come up to slow it down with one of the switches.
If any one has an Idea how to do this I would love to know. I tried looking at the manual but couldnt find it (Probably because I didn't look hard enough)
When the airplane lands I want all of the flaps (Ailerons and Elevator) to come up to slow it down with one of the switches.
If any one has an Idea how to do this I would love to know. I tried looking at the manual but couldnt find it (Probably because I didn't look hard enough)
10-04-2005, 11:52 PM
#2
Member
Join Date: Jun 2005
Location: bakersfield, CA
Posts: 69
Likes: 0
Received 0 Likes
on
0 Posts
RE: Futaba 9 CHP/ 9 CAP controller question!
Your radio can do that without breaking a sweat. If you call the 800 # in your manual, or check Futaba support on this site.
10-05-2005, 09:04 AM
#3
RE: Futaba 9 CHP/ 9 CAP controller question!
http://www.futaba-rc.com has a ton of faq's for that radio.
Look under glider programming for crow and acro programming for airbrake mixing.
Look under glider programming for crow and acro programming for airbrake mixing.
10-06-2005, 06:48 AM
#4
RE: Futaba 9 CHP/ 9 CAP controller question!
We normally call it a TRANSMITTER.
Flaps are control surfaces mounted inboard on the wing to provide additional lift.
Ailerons and Elevators are, well, ailerons and elevators.
The 9C transmitter can do all these. Just keep reading
Flaps are control surfaces mounted inboard on the wing to provide additional lift.
Ailerons and Elevators are, well, ailerons and elevators.
The 9C transmitter can do all these. Just keep reading
