Your thoughts on Expert servos needed
#1
Thread Starter
My Feedback: (41)
Your thoughts on Expert servos needed
I need to buy a decent number of servos for 3 new planes I'm building. All 3 planes are 60 sized and less but all have oversized control surfaces for 3D flying. I have been researcing the servos available on the market place and I like the specs vs. the cost of the Expert servos from Horizon Hobbys. The 3 servos are the SL571,SL561 and the SL661. I currently use a mix of JR digital servos on my 2 meter pattern planes and JR 537 standards on my sport planes.
Who makes the Expert servos and are they a good enough servo. Would you buy these or skip them and buy a different brand? Any feedback or opinions are appreciated. Thanks Mike
Who makes the Expert servos and are they a good enough servo. Would you buy these or skip them and buy a different brand? Any feedback or opinions are appreciated. Thanks Mike
#2
My Feedback: (15)
Expert servos
Hello Mike... I too have purchased several of the expert servos-dont remember the # on them. I was trying to get something like a futaba 148 servo but w/ a ball bearing. Mine has around 47 oz of torque w/ ball bearing and seen to be a good all around servo.I did ask the sales guy were I bought mine at and he said JR makes these but I'm not sure. The servos went in a 4*40 and a 60 size Zero warbird. Hope this helps...... John