Returning digital servos to default
#1
Thread Starter
My Feedback: (53)
Returning digital servos to default
I have a couple of Hitec 5645 servos that have ben slowed down by their previous owner to use as retract servos. Is there any provision for returning them to their default speeds, or must this be done with a programmer of some kind?
#2
My Feedback: (11)
RE: Returning digital servos to default
You need a hitec servo programmer or a friend that already paid for one. If its only a couple and you want them reset it might be cheaper sending them in to a service center than buying a programmer HPF-10
http://www.hitecrcd.com/ has the info for returning them for service.
http://www.hitecrcd.com/ has the info for returning them for service.