Cirrus 704 mg servo's
#1
Thread Starter
My Feedback: (4)
Join Date: Apr 2005
Location: Las Vegas,
NV
Posts: 123
Likes: 0
Received 0 Likes
on
0 Posts
Cirrus 704 mg servo's
Hey all
Has anyone tried these servo's? I am leary but their posted specs at 190+ oz at $30.00 is tempting. I normally use Hi-tek digitals(5645 mg) from my LHS at around $80.00. As always, cost is an issue, just ask my wife. My latest project, a G.P. Cap 232 needs 5 high torque servo's. At a savings of $250.00 if the servo's are trustworthy...nuff said.
I read an old thread on RCU and there were a lot of different opinions but most dealt with standard servo's in smaller .40-.60 planes, not much on the high torque ones and it was over a year old. Looking for some feed back from someone who is using the new ones now.
Not looking to save a couple hundred bucks at the cost of a plane.
Any feed back would be eagerly appreciated.
Thanks,
Rod
Has anyone tried these servo's? I am leary but their posted specs at 190+ oz at $30.00 is tempting. I normally use Hi-tek digitals(5645 mg) from my LHS at around $80.00. As always, cost is an issue, just ask my wife. My latest project, a G.P. Cap 232 needs 5 high torque servo's. At a savings of $250.00 if the servo's are trustworthy...nuff said.
I read an old thread on RCU and there were a lot of different opinions but most dealt with standard servo's in smaller .40-.60 planes, not much on the high torque ones and it was over a year old. Looking for some feed back from someone who is using the new ones now.
Not looking to save a couple hundred bucks at the cost of a plane.
Any feed back would be eagerly appreciated.
Thanks,
Rod