servo question
08-03-2007, 04:42 AM
#1
Member
Thread Starter
Join Date: Mar 2007
Location: Wyongah, AUSTRALIA
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
servo question
hey all,
i need a quick question answered. im looking into a project and a servo will need to be involved. is it possible for a servo to make multiple rotations? or will it just keep its end points? how could i give it the same affect as having multiple rotations if it wont work? basically i need something pulled away on command.
cheers
i need a quick question answered. im looking into a project and a servo will need to be involved. is it possible for a servo to make multiple rotations? or will it just keep its end points? how could i give it the same affect as having multiple rotations if it wont work? basically i need something pulled away on command.
cheers
08-03-2007, 01:45 PM
#5
Senior Member
My Feedback: (1)
Join Date: Jan 2002
Location: Poway, CA
Posts: 3,531
Likes: 0
Received 0 Likes
on
0 Posts
RE: servo question
http://www.hitecrcd.com/servos/show?name=HS-785HB
This is the Hitec 785HB sail winch servo that has 3.5 turns from end to end.
Mike.
This is the Hitec 785HB sail winch servo that has 3.5 turns from end to end.
Mike.
08-03-2007, 03:05 PM
#6
Senior Member
RE: servo question
ORIGINAL: koolkidd hey all, i need a quick question answered. im looking into a project and a servo will need to be involved. is it possible for a servo to make multiple rotations? or will it just keep its end points? how could i give it the same affect as having multiple rotations if it wont work? basically i need something pulled away on command.
cheers
cheers
If HS-785HB does not provide for your needs, refer to the list of modifications to servos and TX available on my web page under "Radio Systems, Accessories, Alterations and FAQ" and sub section thereof "Servo & TX alterations, calculators, clonepacs, make an ESC or winch, FAQ."
Regards
Alan T.
Alan's Hobby, Model & RC FAQ Web Links
