DX7 What am I screwing up?
08-13-2007, 03:12 PM
#1
Thread Starter
My Feedback: (139)
Join Date: Jan 2002
Location: Lexington , KY
Posts: 869
Likes: 0
Received 0 Likes
on
0 Posts
DX7 What am I screwing up?
I've been installing my servos through my DX7 in my new Tamjets F-16. I have one elevator on the elevator in the receiver and one on AUG 2 with AUG 2 slaved to the elevator. Everything has been working well, but I needed to unhook everything in order to plum the wires through the fuse. of the plane. A few days later I got around to plugging it back in and when I turned everything on, the elevators went directly to full up as the new center. From that position, I'm able to move the elevators up and down with the radio, but the new center position is pretty much full up on both stabs. Now I didn't adjust anything. Does anyone know what I did wrong? Should I bind everything again after I hook it up?
Please help,
PJ
Please help,
PJ
08-13-2007, 06:20 PM
#3
My Feedback: (50)
RE: DX7 What am I screwing up?
ORIGINAL: lovetoflyguy
I've been installing my servos through my DX7 in my new Tamjets F-16. I have one elevator on the elevator in the receiver and one on AUG 2 with AUG 2 slaved to the elevator. Everything has been working well, but I needed to unhook everything in order to plum the wires through the fuse. of the plane. A few days later I got around to plugging it back in and when I turned everything on, the elevators went directly to full up as the new center. From that position, I'm able to move the elevators up and down with the radio, but the new center position is pretty much full up on both stabs. Now I didn't adjust anything. Does anyone know what I did wrong? Should I bind everything again after I hook it up?
Please help,
PJ
I've been installing my servos through my DX7 in my new Tamjets F-16. I have one elevator on the elevator in the receiver and one on AUG 2 with AUG 2 slaved to the elevator. Everything has been working well, but I needed to unhook everything in order to plum the wires through the fuse. of the plane. A few days later I got around to plugging it back in and when I turned everything on, the elevators went directly to full up as the new center. From that position, I'm able to move the elevators up and down with the radio, but the new center position is pretty much full up on both stabs. Now I didn't adjust anything. Does anyone know what I did wrong? Should I bind everything again after I hook it up?
Please help,
PJ
