JR 12X in Mode 3
#1
Member
Thread Starter
Join Date: Nov 2007
Location: Victoria, BC, CANADA
Posts: 42
Likes: 0
Received 0 Likes
on
0 Posts
JR 12X in Mode 3
Hi Everyone,
I own a couple of the JR 2.4 X9303 radios and I am in the process of switching over to Mode 3. Since I was about to send in my radio to Horizon for the frayed wire issue I asked if this was possible. Horizon has advised me that the X9303 cannot be rewired into Mode 3 but the standard 9303 can [].
I was wondering if the new JR 12X can be selcted to operate as Mode 3 or sticks selected to the Mode 3 preferences?
I own a couple of the JR 2.4 X9303 radios and I am in the process of switching over to Mode 3. Since I was about to send in my radio to Horizon for the frayed wire issue I asked if this was possible. Horizon has advised me that the X9303 cannot be rewired into Mode 3 but the standard 9303 can [].
I was wondering if the new JR 12X can be selcted to operate as Mode 3 or sticks selected to the Mode 3 preferences?
#2
Senior Member
Join Date: Mar 2008
Location: Sluff, UNITED KINGDOM
Posts: 445
Likes: 0
Received 0 Likes
on
0 Posts
RE: JR 12X in Mode 3
The 12X cannot be configured as a true Mode 3. The digital trims will end up crossed on the screen ( although they will be in the correct position for the sticks, the right trim would show up as the left trim on the display)
This is a "problem" inherited from the 10X.
As for the X9303, this has me baffled as it uses the exact same system as the XP9303 and therefore should easily be converted by Horizon.
This is a "problem" inherited from the 10X.
As for the X9303, this has me baffled as it uses the exact same system as the XP9303 and therefore should easily be converted by Horizon.